REC Active BMS
Product Downloads
ABMS-1-300x193-no-background
actvie-bms-victron1-large
actvie-bms-victron
Previous image
Next image
REC Active BMS Features:
  • Li-PO, LiFePO4, LiFeYPO4, LiCoO2, LiMnNiCo and LiMnO4 Lithium-Ion chemistry
  • up to 3,000 Ah when used with quality matched cells
  • 4 series connected cells per unit
  • high efficiency 2 A bi-directional active balancing (pack to cell and cell to pack)
  • IP65 protection enclosure, AMP 35 pin water resistant connector
  • 2 – 5 V measuring range, 2 mV accuracy
  • up to 2 digital temperature sensors
  • shunt current measurement
  • robust and small design
  • galvanically isolated RS-485 and CAN communication protocol
  • two programmable fused relay output
  • two programmable fused digital output
  • ON/OFF switch
  • LED and buzzer status indication
  • bootloader
  • error LED + buzzer indicator
  • PC user interface for changing settings, data-logging and firmware update
  • compatible with REC LCD touch display for monitoring
  • also compatible with Victron inverters for solar applications
pikaREC.png
Microcontroller:
  • low power microcontroller RTC
  • custom made software with bootloader for remote firmware update
  • 60 mW self power consumption with disabled CAN and all outputs
pikaREC.png
RS – 485 communication:
  • galvanically isolated RS-485 communication
  • Slave configuration
  • RS-485 driver primary side supply is activated with Master connection to save energy consumption
  • fully compatible with REC LCD touch display or PC user interface BMS Master control
pikaREC.png
Active Balancing:
  • 2A cell equalizing with active balancing with synchronous flyback bi-directional energy transfer: cell to pack and pack to cell
  • top side and bottom side balancing prolong the cycle duration due to the weakest cell
pikaREC.png
Outputs:
  • two fused relay outputs with NO and NC pins
  • two fused galvanically isolated/non-isolated digital outputs with PWM option
pikaREC.png
Galvanically Isolated CAN:
  • galvanically isolated CAN
  • 100, 125, 250, 500, 1 MHz bit-rate selection
  • message programming
  • disable option
pikaREC.png
Pre-wired ABMS Harness
  • Speeds installation and reduces chance of error
  • 5 labelled individual cell wires (l = 1m)
  • Relay output wires, digital output wires (l = 0.5m)
  • RS485 cable, includes DB9connector for direct connection to an LCD display or PC (l = 0.5m)
  • CAN cable (l = 0.5m)(Interface cables to Victron or WS500 Smart Regulator are also available)
  • remote ON/OFF switch (l = 1m) for disabling your system.  This switch can even be tied into the WiFi Module to provide remote enable-disable functionality